Air Duct Cleaning, Duct Cleaning service, Dryer vent Cleaning, Clean air duct

Go to content

Furnace Cleaning: Tune-up your forced air furnace today and save heating bill


Furnace Tune-up

Furnace Tune up is one of the most necessary preparation before the cold weather sets in for the winter season. It is always best to get your furnace serviced before the winter season sets in to avoid any problems.

A qualified technician usually performs furnace service in the following steps.

Step 1
Turn the circuit breaker off to the forced air system. The home electrical box should have the circuit breaker clearly marked.

Step 2
Locate the access door to the blower compartment area. It is usually located at the front of the forced air heating unit.

Step 3
Lift up on the door panel, and remove it from the unit. Some model may have two screws located at the top of the door panel.

Step 4
Remove the air filter from the unit and if possible cleans it out.

Step 5
Use a vacuum to vacuum out the blower compartment area.

Step 6
Inspect the motor to see if there are two oiling ports. If required, check the oil level.

Step 8
If any, inspect the belt and look for cracks, splits or any other type of excessive wear.

Step 9
Clean out the burners and heat exchanger.

Step 10
Clean up the air conditioning coils on top of the furnace.

Step 9

Insert a air filter. Install the door panel back onto the unit, and secure it with the retaining screws if equipped.

Step 10

Turn the circuit breaker back on to the forced air system.

Air Duct Cleaning Home Page

Home Page | About Us | Services | Rates | Book Online | Contact US | Savings | NADCA Video | FAQ | Affiliates | Site Map

Back to content | Back to main menu